eMAX Mini

filipeleite1

Hello;

I made this update and everything works fine, now I can share the internet using the mobile phone as an access point (HotSpot), however, there is a problem that the phone now has and had not with the GPS. Now my mini Emax does not capture GPS signal.
What is wrong? I'll be the only one with this problem? How to solve this?

bencebacsi

mano2web replied at 2016-8-8 03:16
Thank you!

And after I use this flash tool, does it remove my TWRP too?

Using the flashtool competely rewrites the whole software content of your phone so yes, you have to reinstall the TWRP recovery.
The support period (software updates) is about 6 months or until it makes sense. There are no strict rules about that.
The UMi eMAX mini won't get any new updates.

express315

The tool opens with M3M product selected by defafault.
When I try to download a message pops up that my UMI Emax Mini is a T500L product, so there is a mismatch.
There is no matching product on the list. Which one should I use.
No one mentioned it anywhere in the thread.

express315

I took my risk and it was M3M product that loads UMI Emax Mini new ROM.

amedeovolante

I do not understand your post, I can update my emax mini with new rom?

viktor975

\n\nHi for all !!!
Hope someone can help.
Does anyone know what is Error code = 40016 ?
I started to update with 6FAA-ZP1_P5002-Flashtool.EXE my phone and gave an error.
When I power on the phone I get "Encryption unsuccesful" and a button with RESET PHONE, but it does nothing when I push it.

bencebacsi

viktor975 replied at 2018-1-19 07:07
Edited by viktor975 at 2018-1-19 07:26 \n\nHi for all !!!
Hope someone can help.
Does anyone know  ...

Hi,
Did you try to just flash your phone again? The freezing of the flashing process could be caused be a simple connection error or a read error of the sources on your hard disk while flashing. I recommend you to try to flash your phone again and if your issue still persist, try to use another USB cable and/or another PC.

viktor975

\n\n\n\n

bencebacsi replied at 2018-1-21 10:01
Hi,
Did you try to just flash your phone again? The freezing of the flashing process could be caus ...

Hi !
It's not a usb cabel problem.
With QPST Software Download I can make xQCN Backup and Restore.
I see the phone with "adb devices" command as: c73728bd sideload at command prompt.
Then I try to upload the TWRP recovery image, but fail, even from sd card. The phone can not extract it because there is no mounted partition ...

"E: failed to mount /cache (Invalid Argument)" .. and so ...
To resolve the problem I have to delete and rebuild all the patitions ... but I dont know how ....

clon1958

Hello.
Please tell me what is this error

COM7->PC[1] Download F6FAAOAOBUOO.mbn failed!
(Error code = 40016)

At the phone repair program 6FAA-ZP1_P5002-Flashtool.EXE

clon1958

When restore phone 6FAA-ZP1_P5002-Flasht
Phone sewn on different computers
With different cables with the selection of drivers
Programs
eMAX Mini 6FAA-ZP1-P5002 12/17/2015
eMAX Mini 6FA6-ZP1-P5002 11/17/2015
6FA4-ZP0-P5002-Flashtool.EXE
Everywhere else is popping up this error