WIFI and Mac adress

bedelman

Dmitry_rus, thank you for these instructions.  Looks so promising.  I tried to follow your #2, beginning with disabling WiFi, then entering EngineerMode and going to Connectiivty - WiFi.  But as I chose WiFi, I got an error:

Error
Please make sure:
1. Wi-Fi is off.
2. Operation is too frequent, please try later.
3. Turn off Scan Always setting.


#1 I definitely did.  #2 I don't understand.  #3 I don't understand in that I don't know what setting they have in mind.

Suggestions?

Luna4

Dmitry_rus replied at 2019-9-22 00:08
Edited by Dmitry_rus at 2019-9-26 18:53  

Thank you very much for your help, my UMIDIGI POWER EEA has the same problem of random changes of the WiFi MAC.
I have tried with system 2 that you give and it works correctly but, as you already commented, it remains only while it is ON and that is a nuisance.
Can you tell me which config files are responsible for the WiFi MAC randomization to proceed to its modification ?.

In the end I turned to the traditional and I solved it with the SN_Write_Tool that I had to use from the first moment.

Dmitry_rus

bedelman replied at 2019-11-5 14:42
Dmitry_rus, thank you for these instructions.  Looks so promising.  I tried to follow your #2, begin ...

Hi!
You can get such error if you've missed something. Please check again your wi-fi settings (wi-fi should be turned off AND wi-fi scanning should be OFF too!).

Scan is on