UMIDIGI Z Pro V7.01_20170710 Android 7.1.1 ROM - SPFT + OTA release

gerardo96

Something else I forgot to mention before. Every time I turn off and turn On the phone a small message pop's up and says: SIMPROCESSOR. Also it appears when I set the phone in Aeroplane Mode. see attach file. Any help would be appreciated.

bencebacsi

gerardo96 replied at 2017-8-22 19:27
Something else I forgot to mention before. Every time I turn off and turn On the phone a small messa ...

It's just about accessing the SIM processor. The chip on the SIM card contains a very simple microprocessor. The only new thing is to being notified about that access.

Enigma

I know it is off topic, but where I can find good case/protector for the device?? Please gimme links
Sorry for post

Russj

bencebacsi replied at 2017-8-22 18:13
You can add a URL with the dedicated button.

Ahhhhh - Ok..

     I tried the "Image" and Attach"... and they were a total failure of course.. thanx

picture file

Russj

bencebacsi

Russj replied at 2017-8-23 03:17
Ahhhhh - Ok..

     I tried the "Image" and Attach"... and they were a total failure of course.. t ...

So the first step of the calibration is successful but the second step fails with this error message. Is it correct?

jeeeva89

chooks06 replied at 2017-8-21 10:45
I assume you got the latest version updated OTA from Android 6?
Which button did you press to sele ...

Hai,
     I pressed "Volume UP Button + Power Button" and got boot screen there only 3 options avilable then i pressed "Volume Down" button to select recovery.
while i choosen Recovery my mobile gots repeatedly restarting.

I tried all 3 options  Recovery, Fastboot and Normal. Recovery and Normal options made mobile to reboot continuously and in Fastboot mobile got stuck in black screen. If needed i can attach photo.

Thanks for your reply. Kindly help me to fix this

Russj

bencebacsi replied at 2017-8-23 06:59
So the first step of the calibration is successful but the second step fails with this error messa ...

Yes sir... every time..

Russj

chooks06

jeeeva89 replied at 2017-8-23 20:43
Hai,
     I pressed "Volume UP Button + Power Button" and got boot screen there only 3 options avi ...

Looks like the only way is to flash the firmware using SPFT.

Instructions and necessary files have been provided by @Bencebacsi in the first post of each ROM forum.

You'll need to install the MTK drivers if that has not been installed. From there, the phone is connected with power off, after opening the flash tool and selecting the correct scatter file. Suggest to use firmware upgrade option and over write everything.

Take note of relevant warnings in the forum page before starting.

bencebacsi

jeeeva89 replied at 2017-8-23 20:43
Hai,
     I pressed "Volume UP Button + Power Button" and got boot screen there only 3 options avi ...

Hi,
You should flash the recovery partition with SP Flash Tool.

bencebacsi

Russj replied at 2017-8-23 21:39
Yes sir... every time..

Russj

Please run the testing mode by dialling *#*#33#*#*
Select Single Test, then Distance Sensor. There you can real time test the working of the proximity sensor. Moving an object closer to the sensor should increase the displayed value. Please come back with your experience there.