Screen Protector

george_ch

Hi all,

Finally I got my Z Pro and so far so good.
The problem I am having a really annoying twist: THE SCREEN PROTECTOR

I got the following from AliExpress: https://www.aliexpress.com/item/ ... 13010608.0.0.YAuLOi


The thing is the screen protector fits the cell perfectly at the middle but at the edges it's not getting the deal done.

I couldn't take a photo but the picture attached is something similar.
I tried to sketch my problem as possible as I can. (I know my drawing sucks but i am trying)


I tried multiple ones but they are all from the same seller. And I even tried the screen protector of "Samsung A7 2016 (it fits but still the same problem)

Might it be that the cell screen is deviated?

chooks06

Hi mate,

Take a look at this thread and see if you can find your answer.

http://community.umidigi.com/thread-7152-1-1.html

The Z Pro does have the 2.5D thingy and definitely can't find a hard glass protector that "sticks" at the edges. Not even the nano type ones. (see details in the thread).

The first picture in your post shows big bubbles which should be able to be pushed out, from the centre of the phone to the edges. If they cannot, likely the "stickiness" is gone, due to either poor quality, or having re-installed too many times or the screen is not clean enough.

Usually, the stiicky side is still sticky despite having to remove and reinstall due to adjustments, except for the edges.

george_ch

chooks06 replied at 2017-4-28 18:15
Hi mate,

Take a look at this thread and see if you can find your answer.

Thank you mate it really helps to know that someone else shares my concren
I will try and get another screen protector and test it.

chooks06

george_ch replied at 2017-4-28 21:12
Thank you mate it really helps to know that someone else shares my concren
I will try and get anot ...

You're welcome mate. Have a great weekend!