Glass screen protector ?

cloud_9

Anyone had any luck with getting a decent glass screen protector that doesn't protrude from the curved edges?This one one from AliExpress was a waste of time.

chooks06

I too ordered one as part of a bundle from a store at AliExpress.

They shipped accessories to me first but still waiting for the phone.

The protector is the same. I think it has something to do with the rectangle shape of the fingerprint sensor. Probably to provide a bigger contact area since the fingers are flatter at the bottom than at the tips.

Will update with picture when I get home later.

Cheers!

PhilK

I ordered one as part of a bundle from coolicool. They've not shipped anything yet. Will let you what it's like if/when it arrives.

chooks06

Picture attached for reference.

cloud_9

chooks06 replied at 2017-3-28 13:57
Picture attached for reference.

Can you please measure the width of the glass protector?

chooks06

cloud_9 replied at 2017-3-28 19:34
Can you please measure the width of the glass protector?

W about 6.7cm
H about 14.5 cm
Sorry if the measurement has some slight error. Too late in the night to get new battery..

cloud_9

chooks06 replied at 2017-3-28 22:55
W about 6.7cm
H about 14.5 cm
Sorry if the measurement has some slight error. Too late in the nigh ...

This has pretty much the same width as mine (68mm).Anything above 62 +/- 1mm won't fit properly on the screen.

chooks06

cloud_9 replied at 2017-3-29 18:37
This has pretty much the same width as mine (68mm).Anything above 62 +/- 1mm won't fit properly on ...

Guess it's one supplier, a few retailers. Using different packaging as well. Getting my Z Pro either today or tomorrow. Will update again.

chooks06

Update..won't be fitting the protector for a while till the phone settles in. In any case, the width of the actual display is about 3mm wider than the protector edges on each side. Likewise at top and bottom edges.

freenext

\n\n
Google Translation
Answer: Hello, as long as the 2.5D glass screen will be equipped with such a tempered film. The reason is that 2.5D glass is a certain degree of curvature, and the tempered film itself can not be made into the arc, which is why the edge (that is, the edge of the arc) out of a little bit of space. Hope I explain that you can understand. Thank you for your message
Umi is a Chinese company and I am a Chinese Hope the ans will help u