problem of charge

samuelb

https://www.youtube.com/watch?v=JJNt_qAR2bQ

so I think this video is bullshit !! ... my real charging time 0-100% is about 2h 39m so I am really disappointed ... ok, I try next charging from 1% but I do not expect a significant improvement :/ ... and ok, I dont have 10h full charging time but I think it is longer than normal for quick charging.
I use original accessories.

Kamillos

In my first two massacre of charging to 100% in 4 hours are from 2% to 100% exactly 01 hours 23 minutes

mangistar

MarcinP replied at 2017-1-28 20:32
Hi
Basically phone should be fully charged from 1% in 1h 40 min up to max 2H without: using phone ...

Hello,
Here is the result of charching as monitored on 3c battery.
(I think is something wrong with the application).
Anyway waiting for your conclusion.
Thanks for your help.

MarcinP

mangistar replied at 2017-1-31 06:07
Hello,
Here is the result of charching as monitored on 3c battery.
(I think is something wrong wit ...

Go to top left three lines - settings - battery - calibration - battery capacity and set 4000.You should go to settings - battery - monitoring - mA retrieval method and set to reverse Android mA.

Maximum voltage should be 4441 mV and minimum 3400 mV
Your battery temperature is very strange too especially under charging and with screen one.
This what I can see I would say that the battery is gone.
This is very strange why you have missing.

MarcinP

The next thing is that under charging your current should be around 1600 - 1900 mA

mangistar

\n\n

MarcinP replied at 2017-1-31 08:44
Go to top left three lines - settings - battery - calibration - battery capacity and set 4000.You  ...

Ok i  will try again as soon as my battery goes down to 1%.
Capacity was setting on 4000 but not the mA method.

zitouni79

now , it s more good, 4 hours for full charg, i ll try 3c battery

MarcinP

Sorry guys I made mistake in 3c battery monitor. Please set as

MarcinP

Another thing what you can do is go to engineering mode.
Open call dialer and type in *#*#3646633#*#* and go to hardware testing - power - charge battery - and look on ADC charge voltage and FG battery current consumption.
Also you can go to log and debugging - battery log and check battery  temperature and battery voltage.

mangistar

MarcinP replied at 2017-2-2 03:31
Another thing what you can do is go to engineering mode.
Open call dialer and type in *#*#3646633#* ...

Hello again,
As i didn't read your post earlier my today's measurement is useless. So i have to wait until the next time.
Btw no power option for me.