Iron pro overheated? Does not turn on

Danny1982

My UMI Iron Pro does not turn on anymore. There was a message "battery is too hot, please remove battery" (in spanish) and I turned it off immediately. Now it is not turning on anymore?
What can I do?

bencebacsi

Dear Danny,

Please try to charge your phone using another wall charger and (if that's available) with another USB cable. Maybe your device received an over voltage from the wall charger.

Danny1982

I have already tried this, but it is not charging at all. Do you have any other solutions?

bencebacsi

In this case I'd use a Charger Doctor to measure of the phone drains some current or nothing. So that's not easy to go to the next step if you can't get a such device. If your phone receives some current from the charger, you should keep it on charger for several hours until it wakes up again. If no amperes drained, then your phone should be repaired.
Without a measuring tool, you can reflash the complete software of your phone with SP Flash Tool.
Link the the recent version: http://community.umidigi.com/for ... peid%26typeid%3D159
If your issue is caused by corrupted software, this process will solve it.

Danny1982

I do not have a Charger Doctor, but the phone was connected all night and it still does nothing. It probably does not receive any current from the charger.
How do I reflash the complete software if my phone does not turns on?
Do you have any other suggestions?

bencebacsi

You have to use SP Flash Tool while your phone is turned off. That's especially good for reinstating bricked phones. Please, get through the linked tutorials on the page.

Danny1982

Can I still recover the data on the phone?

bencebacsi

You may uncheck the data partition in the flasher window if you want to keep your data. However, in that case your flashing action may not be effective. If that happen, you must flash the whole content, choosing the 'Firmware Upgrade' option instead of the default 'Download Only'.