Update v3.0.3.-20160510 whats new?

bencebacsi

piki replied at 2016-5-22 00:24
tomorrow i was go to china repairman..he says me that without name of antenna is impossibile..so p ...

I'll come back with the information as soon as I get it. Until that, the repairman should be able to identify the functions of the available antenna pins.

Shooker

Fingeprint sensor for now did not work already for 5people(1 here and 4 on 4PDA.ru)  after update to Touch v3.03-20160510 , any manipulation with connector (disconnect and firmly reconnect the center connector of the ribbon cable of the bottom PCB. reFalshing etc.)- did not WORKING. BUT if we flash again the ROM FT v3.03-20160423 - it became alive and fingerprint sensor starting to work. So I am asking you again, help people to fix the problem! Please. Maybe it is NVRAM changes trouble, or smth else.

bencebacsi

I already flashed the last two ROM versions back and forth many times but I've never could manage to lose the fingerprint settings. The only way was to disconnect the bottom PCB.
Here's a (quite not scientific) method that can help.

1. Flash the v3.03-20160423 version with SP Flash Tool choosing the 'Format All + Download' option. The nvram partition will be cleared, so you lose your IMEI numbers and WiFi address.
2. Reboot your phone, connect to a wifi router (that's still possible) and process the FOTA update. The nvram partition will be recovered and hopefully you get back the fingerprint sensor as well.

Shooker

Ok we will try, thanks

Shooker

bencebacsi

Shooker replied at 2016-5-24 01:34

did you try after a clean install, before installing any third party apps?

https://dl.dropboxusercontent.com/u/40607441/temp/2016_05_23_19_51_32.mp4

Shooker

after clean intall with 'Format All + Download'  in FT option ..

Maybe we can try to put an old NVRAM.img from 0423ROM in to a new 0510ROM, may it help?

Or you make some changes in new rom, for peple with such as SOFT problem ?

Also waiting for a antenna pin named, it is no so hard  to name it by the engeeners ))  I hope

bencebacsi

Factory ROMs don't contain the nvram partition. A backup can be created with a custom recovery. However, since the fingerprint settings and app are existing at you, I don't think this is an nvram issue. It might be an accidental coincidence of unknown preferences in some devices. Try to run the fingerprint setup without SIM card and memory card installed in your phone and the system language set to be US English. If the fingerprint settings works properly with the latter update, maybe that would be wiser to skip the current one and wait for the next one. I haven't changed anything in the new ROM, of course.
I still haven't got a feedback from the engineers about the antenna configuration. It seems all antennas are integrated (the bottom panel is not used), except the GSM antenna, that stands for the 1-2 antenna pins from the right. That's linked by the coaxial cable, not through the center ribbon cable of the bottom PCB.

Kaikoku

Hi,
Same problem here with the fingerprint. No such option since the last update.
I've flashed the rom with SP flashtool but the option still desapear...
I think that there is a real issue, many people seem to have that problem.
Regads

bencebacsi

Kaikoku replied at 2016-5-30 02:01
Hi,
Same problem here with the fingerprint. No such option since the last update.
I've flashed the r ...

Hi,

We still cannot reproduce this issue on any devices. Maybe it can be a conflict with a third party app. I suggest you to check the fingerprint settings immediately after flashing this version, before installing any third party apps and before connecting to the internet by any way.

Regards,
Bence