Edited by Acciaio at 2016-1-27 06:30 \n\nRegarding touch screen parameters in engineering mode :Yes it works fine but....did you check if after rebooting or switched on the parameters remain? All users reported that they disappear and the parameters return to stock values
I can confirm that the solution of touch screen sensitivity changing parameters in engineering mode is not permanent. Once you switch off the phone the changed parameters return to the stock ones..
Yes, i confirm that the configuration via MTK engeneering mod will reset after a simple reboot.
Moreover the touch problems will not solve so good in this way.... we need a new firmware.... UMI u understand this ?
Author: miskin121
[Copy link]
Peep Card
Radar card
Post time 2016-1-26 18:11:22
Magic mirror
