UMIDIGI X (EU) V1.0_20191024.V3.03 ROM - SPFT + OTA release

bfef

Modifying the bandmode didn't work at all and in fact stopped all data! So the problem persists.

vir_silva

Armindo replied at 2019-11-12 21:36
Hello,
Some phones when droped activate a security system
that doesn't allow turning on the phone. ...

Hello,
I did the suggested, opened the phone and turned off the battery, waited about 5 minutes I turned it back on, but the result is the same I have a china brick.
This was my first and last purchase of umidigi.
Every time I try to turn on the phone through software I always have the same error
ERROR: STATUS_DA_HASH_MISMATCH (0xC0070004)
Can you help me please?

bencebacsi

vir_silva replied at 2019-11-15 07:44
Hello,
I did the suggested, opened the phone and turned off the battery, waited about 5 minutes I  ...

"my son yesterday dropped my phone"
Probably something is broken inside or an internal cable connector has moved from its position. That should be checked rather then pretending that you've received a faulty phone.

vir_silva

Hello again.
When I said I fell it was off a table about 50cm in the room.
I've gotten other phones that fell much higher about 1m from my pocket and nothing happened.
As I said, I already opened the phone and disconnected the battery.
In this situation for just once after many attempts I managed to flash the phone.
1st only with download selection.
Nothing happened.
2nd time with option: firmware upgrade.
It was until the end.
I disconnected the cable, reconnected the battery, and still does not turn on.
Any ideas, could it be the cell phone battery?
How do I measure or get another battery.
I accept suggestions or options.
Thanks in advance.
Ps: If I try to flash the phone now, I already get the same error reported at the beginning.