UMI IRON PRO bricked??

XTC1

I need help, I am very nervous.

I installed the TWRP recovery with Rootjoy and I had no problems. After go to recovery mode to install the Gapps http://opengapps.org/ I installed the ARM 64 5.1 STOCK. Then I press restart and remains in the Android logo and goes no further. If I connect to ROOTJOY detects it and I can see the files. But don´t start. I need help please.

Sorry form my english



                                                                                    

bencebacsi

nigelwoods replied at 2015-12-28 02:11
Hello! I had a similar problem! I turned my phone into a brick! I installed custom recovery TWRP, an ...

Hi,

Try to repair the IMEI numbers with this tool: http://community.umidigi.com/forum.php?mod=viewthread&tid=1375&extra=page%3D1%26filter%3Dtypeid%26typeid%3D106

oneillryan2000

I had the same problem in that I was trying to get my banking apps working ended up stuck on the android screen, I had to re-flash the original Iron pro ROM using the instructions & flash tool and it eventually got going again....when it started up again it stayed on the android logo for a long time ( 2-3 minutes guess) so be patient  

XTC1

Thanks for answering
That's what I've done and it has worked . Now I'm not root , Do you know what is the best method to root?

nigelwoods

Hello! I had a similar problem! I turned my phone into a brick! I installed custom recovery TWRP, and through him to reset the system. Phone not boot icon on android! Then I decided to flash the phone with Spflash tools, but chose the item "format all-download, and then began working as a normal phone but imei disappeared.

nigelwoods

bencebacsi replied at 2015-12-28 08:04
Hi,

Try to repair the IMEI numbers with this tool: http://community.umidigi.com/forum.php?mod=vie ...

Thank you!!!
But i do right  imei in enieneer mode
So can you help me with problem about sound???? When i listening music, i heard noise!!!!

bencebacsi

nigelwoods replied at 2015-12-28 12:30
Thank you!!!
But i do right  imei in enieneer mode
So can you help me with problem about sound???? ...

Then you haven't lost your nvram partition by the formatting.
The sound issue is not software related. Using higher impedance (32 ohm or higher) headphones might reduce that noise, but most in-ear headphones has just 16 ohm impedance.

nigelwoods

bencebacsi replied at 2015-12-28 23:03
Then you haven't lost your nvram partition by the formatting.
The sound issue is not software rel ...

no, i created new NVRAM, then i changed it in engineer mode because new
not correctly displayed

bencebacsi

nigelwoods replied at 2015-12-28 23:43
no, i created new NVRAM, then i changed it in engineer mode because new
not correctly displayed
...

Created or restored?

nigelwoods

created witn some chinaprogramm