This is the downloadable OTA update file of the V3.01_20161117 (Android 6.0) firmware for UMI Plus
In order to be able to upgrade your UMi Plus to Android 7.0 via FOTA method (Wireless update), you have to have this latest Android 6.0 version installed on your device. UMI Plus receives all updates automatically via FOTA method. You need this update file only if you haven't received or - due to the lack of internet access - you cannot receive it automatically. This version will not be published in SP Flash Tool format!
Manual (local) OTA update method instructions 1. Copy the downloaded .zip file to either the internal memory or the SD card of your phone 2. Go to Settings --> About phone --> Wireless update 3. Tap the 3-dot menu button at the top right corner and select Local updates 4. Brows for the ...update.zip file and select it 5. Tap Install now, comfirm the process with OK and wait until the process will be finished
Update file for manual OTA update: UMi_Plus_V3.01_20161117_update.zip Compatible with TWRP but cannot be installed on modified (ever rooted) systems
Optional method (in case if the manual OTA update gets stuck): Install from recovery You need a microSD card (with at least 4GB capacity) installed in your phone! - Copy the ...update.zip file to your SD card
- Press and hold the volume-up and power buttons together until your phone restarts. It needs about 10 seconds or a little bit less if your phone was already powered off.
- When your phone is restarted, immediately release the power button but still hold the vol-up button until you see a lying android figure with an exclamation mark in red triangle on its tummy.
- Press and hold the power and vol-up buttons (in this order) together, then release them to call the recovery menu. Now you can move with the volume buttons and select an item with the power button.
- Move to ‘Apply update from SD card’ and select it.
- On the next screen brows for the update file and select it. The updating process will start and needs a few minutes to be finished.
- After a succcessful installation you can read the ''Install from sdcard complete'' message and the receovery menu is available again.
- Select 'Reboot system now'. Alternatively you can perform a factory data reset here by choosing 'Wipe data/factory reset'
|