Install custom recovery (TWRP, CWM etc.) and root

s2lite

How can I analyze how twrp is to be installed for a lutefen s2 lite?
Bootloader open

DiegoRamos

Hello!

I have a S2 lite, after the last update I had a problem, I received the following message on the screen after about 8 hours of use: "The interface stopped." I rebooted the device several times but the same error continued, I had no access to anything , just turn it on and off.
I tried to format via recovery, but I did not succeed, the message "no data" appeared strange, but I tried to format it through SP Flash Tools, the formatting is complete, but the phone will not turn on and will not load anymore.
When connected to the computer, the sound is connected and disconnected simultaneously. I can normally save new room, but I can not boot the device.

If so, is this procedure enough or do I have to do something else?

Thank you in advance.

Cjcj

Reading the list in the first post this means the A3 can't be rooted yet?

Thanks

mmkc21

Bonjour,
j’ai besoin d’aide à la racine d’un diamant de UMI.
En effet, j’ai suivi la procédure jusqu'à ce que mon téléphone est redémarré. Numéro 6 de phase
j’ai redémarrer en appuyant sur volume + et power, puis j’ai le menu :
racine Select Mode : Normal de recouvrement - FlastBbot -.
je sélectionne (récupération).
Deuxième menu, je sélectionne (appliquer mise à jour de carte SD)
troisième menu, je sélectionne (SR5-SuperSU-V2.82... zip)
j’ai le message suivant : Installation abandonnée.
Vous pouvez m’aider à résoudre mon problème
Merci
cordialement
désolé pour la traduction, mais je suis Français

Chicato83

Hello I´m new here and I want to know how to remove the data encryption after install TWPR thanks.

p0w3r

Hello all, is available the TWRP custom recovery for Umidigi One Max? Can be installed the one available for One Pro?  Thanks in advance for the replies.

Aksel

p0w3r replied at 2019-1-29 16:15
Hello all, is available the TWRP custom recovery for Umidigi One Max? Can be installed the one avail ...

Doesn't work. Tried it. Didnt brick or anything just messed up the stock recovery. I just flashed the original back and it was ok.

s80_gad

Hello everyone, will that tutorial work for Umidigi A3 Pro? Or is there a specific thread for that phone. I have just received the phone and haven't started it yet - is there a way to make a full backup of the phone or I can use any of the stock roms after that? Thanks

p0w3r

Aksel replied at 2019-1-30 10:30
Doesn't work. Tried it. Didnt brick or anything just messed up the stock recovery. I just flashed  ...

Thanks, Aksel. We will wait for the TWRP...

lobyte

TWRP for F1 - no data partition is mounted and no root access.