UMI eMAX Touch screen issue + Ghost touch issue

steve0b

Try sgs screen booster, adjust your sensitivity settings and apply. Since I've been using it not had any issues but not sure if this is down to luck or if this actually works.....?

abelnorchis

\n\n

steve0b replied at 2015-10-20 16:26
Try sgs screen booster, adjust your sensitivity settings and apply. Since I've been using it not had ...

Ok, I'll give a try.

SGS screen booster doesn't work for me. Maybe I don't know wich are the right settings? Could you tell me please?

steve0b

abelnorchis replied at 2015-10-21 00:37
Edited by abelnorchis at 2015-10-22 05:18 \n\n
Ok, I'll give a try.

Just turn all the settings up (bars on max) and apply, basically lower the sensitivity to min!! I believe the settings are only applied for a short period of time then reset however since I played around with this app my ghost issue have completely gone so far!!! Not sure if this is more down to luck?

andrija00

steve0b replied at 2015-11-3 06:19
Just turn all the settings up (bars on max) and apply, basically lower the sensitivity to min!! I  ...

Doesn't work for me.

abelnorchis

Doesn't work for me too. I'm seriously thinking to send back to the reseller.

bencebacsi

I know, this is a very long thread, so that's hard to get through the whole topic, but I told you multiple times, this is a hardware defection caused by bad assembling or shoddy hardware. Sometimes it can be better by software tweaks, but the issue itself cannot be permanently resolved without repairing the hardware. So yes, everybody who got a such defective phone, should return it to the reseller for a replacement. Tweaking is pointless since that never can give you a stable and permanent solution.

andrija00

\n\nI think it goes better for a while when I press down the screen while cleaning. I suppose somethnig in the screen isnt good assembled so it has to be pressed down to make the contact of the screen! Afer some time the screen goes crazy again!

andrija00

bencebacsi replied at 2015-11-10 19:13
I know, this is a very long thread, so that's hard to get through the whole topic, but I told you mu ...

Why don't UMI repair phone organized? We who have problems with emax could contact UMI directly? This would be fair!

bencebacsi

andrija00 replied at 2015-11-15 00:43
Why don't UMI repair phone organized? We who have problems with emax could contact UMI directly? T ...

Because that's impossible for a relatively small team to handle all the hundred thousants of buyers by their own. Warranty handling is the traders responsibility.

beraydeath

I've just brought a Umi Emax (yet to receive from Bang Good) . I hope this touch screen problem does not happen with the Umi I receive. I did own a HTC one m7 but dropped and cracked the screen. I replaced the screen x2 times with Chinese Icp screen similar to that on the Umi Emax.  With these chinese screen I then experienced ghost touches on the screen of my HTC because the glass would contact on areas of the digitizer. It has nothing to do with software its all engineering faults with glass not installed flat with the right gap to the Digitizer.

Umi sounds like they need to work on this during the construction of their phones and have better and more critical testings after completion of phone builds.

I sure hope my Umi is working without Ghost touch.

Ben