UMI eMAX Touch screen issue + Ghost touch issue

abelnorchis

Don't know if I'm right, but, as suggested by bencebacsi, maybe the problem could be "the running out of free RAM caused by too many background app". Yesterday and today, I  tried to keep clean the ram, by closing all apps from the  task manager once end to use that. At the monment, I can confirm no more ghost touch. The test continue.

bencebacsi

abelnorchis replied at 2015-10-20 04:23
Don't know if I'm right, but, as suggested by bencebacsi, maybe the problem could be "the running ou ...

Interesting experience. Next time if you get the ghost touch issue again, you should check the amount of free RAM at that moment.

abelnorchis

\n\nOk, guys, wrong way. The issue happens also when the task manager is completely empty of apps. But I notice that: when the issue appeared, I pressed the Home button, enter the task manager, return to the app and the issue was disappeared. My next try is to enter task manager and exit and see what happens.  Obviously I have to wait the ghot touch appears again.

steve0b

Try sgs screen booster, adjust your sensitivity settings and apply. Since I've been using it not had any issues but not sure if this is down to luck or if this actually works.....?

abelnorchis

\n\n

steve0b replied at 2015-10-20 16:26
Try sgs screen booster, adjust your sensitivity settings and apply. Since I've been using it not had ...

Ok, I'll give a try.

SGS screen booster doesn't work for me. Maybe I don't know wich are the right settings? Could you tell me please?

steve0b

abelnorchis replied at 2015-10-21 00:37
Edited by abelnorchis at 2015-10-22 05:18 \n\n
Ok, I'll give a try.

Just turn all the settings up (bars on max) and apply, basically lower the sensitivity to min!! I believe the settings are only applied for a short period of time then reset however since I played around with this app my ghost issue have completely gone so far!!! Not sure if this is more down to luck?

andrija00

steve0b replied at 2015-11-3 06:19
Just turn all the settings up (bars on max) and apply, basically lower the sensitivity to min!! I  ...

Doesn't work for me.

abelnorchis

Doesn't work for me too. I'm seriously thinking to send back to the reseller.

bencebacsi

I know, this is a very long thread, so that's hard to get through the whole topic, but I told you multiple times, this is a hardware defection caused by bad assembling or shoddy hardware. Sometimes it can be better by software tweaks, but the issue itself cannot be permanently resolved without repairing the hardware. So yes, everybody who got a such defective phone, should return it to the reseller for a replacement. Tweaking is pointless since that never can give you a stable and permanent solution.

andrija00

\n\nI think it goes better for a while when I press down the screen while cleaning. I suppose somethnig in the screen isnt good assembled so it has to be pressed down to make the contact of the screen! Afer some time the screen goes crazy again!